How to check the engine oil

Firstly, check the engine oil. The vehicle is parked on a level road. Unplug vernier check the amount of oil, oily If within (F) and (L) of the two marked lines, then within the normal range, if less than (L) bits. You should add the specified models of oil, liquid fuel can not be higher than after (F) bit.

Secondly, the check engine coolant level. Engine heat machine state, do not open the radiator cap, otherwise you might be spilled coolant or high temperature steam burns. Such as the engine cooling, check the coolant level should be between full-bit and low, or should add distilled water or purified water (not mineral water plus) or frozen liquid, adding water surface height can not exceed the full bit. Coolant found a short time to reduce quickly, the cooling system launch crp123 should be checked for leaks or the service station to check.

Thirdly, the braking surface inspection. Braking is also high, then the normal between low. If the brake fluid is close to the lower limit or below the lower limit indicates that the system may have a leak or the brake shoe wear too, should go to the service station and timely maintenance.
Additional brake fluid, pay attention to add the same type of brake fluid, to prevent damage to the cup, attention to protecting the paint to prevent corrosion paint.

Fourthly, the clutch master cylinder surface inspection. Clutch level between high and low level between said normal, if less than the standard line, it may be the master cylinder or wheel cylinder cup damaged.   Launch x431  In the engine operating state will appear difficult or impossible to hang hanging file file behavior, to the nearest service station immediate overhaul.

Lastly, battery maintenance checks. Check the battery is firmly fixed electrolyte should be between the upper and lower limits, close off the assembly line should be timely additional electrolyte or distilled water to the high line. Maintain the positive and negative battery cables in good contact and keep the battery clean and dry. Place a long time to take off the vehicle battery positive and negative cables, separated by about half rewire about 20 minutes after starting the engine, if the battery is clearly insufficient to timely charge.

another article click:how to  Maintenance our car